Everything an integrator, specifier, or hardware engineer needs to build with the Domatic platform — system overview, product spec sheets, and reference materials. Pick a document below to open it.
A high-level introduction to the Domatic system, end-to-end.
A power-distribution and building-automation system that connects, powers, and controls fixtures over a single low-voltage NEC Class 2 pair — combining safety, simpler wiring, and software-defined automation across lighting, sensors, doors…
14 products in the Domatic platform · 8 marked as draft. Click any card to open its spec sheet.
The 90W CC LED Driver is a high-performance, 2-channel constant-current LED driver designed for premium architectural and commercial lighting applications. Powered via 48 VDC over the Domatic Bus, it delivers up to 90W of precisely controll…
The Compact CC LED/Sensor Driver is an ultra-compact, 2-channel constant-current LED driver built for space-constrained architectural lighting installations. At just 86 × 37 × 22 mm it delivers up to 50W of precisely controlled output with…
The DOM-S-1 is a decora-format input device for the Domatic Bus. It mimics a traditional dimmer switch with a paddle-style rocker for momentary up/down control plus a 9-LED status strip — but because every behavior is software-defined in th…
The Multi-Sensor Driver is a compact sensor interface that connects commercial building sensors to the Domatic Bus over a single 2-wire CL2 cable. It features a software-selectable 24V or 3.3V power output for sensor power, three 0–24V anal…
The PowerHub-10 is the 10-port controller for the Domatic Bus. Field drivers and fixtures connect through 10 NEC Class 2 output ports — each delivering up to 100 W of combined power and data over a single 2-wire CL2 cable, for a hub total o…
PowerNode Module lets manufacturers create Domatic Bus-compliant devices. The Domatic Bus carries class-2 low-voltage DC power and IP networking on a single 2-wire pair — dramatically reducing copper compared to traditional Romex and simpli…
The 80W Speaker Amplifier drives a stereo speaker pair at up to 40 W per channel from a single Domatic Bus connection. With support from the PowerHub it presents itself on the building network as an available speaker target — playable from…
The 90W CV LED Driver is a 5-channel constant-voltage LED driver for the Domatic Bus. It outputs a software-controlled variable voltage that is pulse-width modulated for smooth dimming, and supports a wide range of LED formats — single-colo…
The Door Access Controller is a flexible, single-door access controller that brings credential readers, electric and magnetic locks, exit buttons, doorbells, and door-ajar sensors onto the Domatic Bus.
The Dry-Contact Switch Module is a compact contact-switch interface with four independent dry-contact inputs, one 3-pin plug per input, that fits inside a single 1-gang wall box.
The Fan Controller is an embedded controller-board reference design that lets OEMs put their ventilation fans on the Domatic Bus. It replaces the typical AC-DC power adapter and basic speed-control circuitry inside a fan with a single board…
The HVAC Bridge connects building HVAC equipment — thermostats, controllers, AHUs, VAVs, and other RS485-based devices — to the Domatic Bus. It exposes a single RS485 channel that speaks MODBUS, BACnet, and other RS485 protocols, with per-d…
The PoE Bridge creates a single PoE PSE (Power-Sourcing Equipment) port that lets an off-the-shelf PoE device draw power from — and communicate over — the Domatic Bus.
The RS485 Shade Driver connects up to two motorized window shades to the Domatic Bus. It supplies 24 VDC power and an RS485 serial control channel to compatible shade motors over a single RJ45 cable per motor — bringing roller, drape, and a…